The transportation cost of raw materials and energy is skyrocketing, which has a direct impact on the price of adhesives and the availability of these products. To be honest with you, I was hoping to have some better news for you, but it is anticipated that this growth will carry on at least until the year 2008 is over. However, the total cost of ownership is something that really needs to be considered with regard to our adhesive system, Bruce. What exactly do you mean when you talk about the "total cost of ownership"? This is because the price of the adhesive itself is not the only expense associated with running the system.



In doing so, they must take a number of factors into consideration, including the costs of downtime, maintenance, component costs, low production costs, low mileage costs, and cleaning costs. As a matter of course, in accordance with PMM I (that is, hot melt adhesive web), the cost of hot melt adhesive web will become apparent once they have arrived at the location.




Once coking has taken place, it will prevent your dispensing equipment from functioning properly, which will result in unplanned downtime, an increase in the costs of parts and maintenance, and a decrease in production


  • What exactly does this imply

  • Typically, they will need to be distributed because they will become thicker, the pressure in the system will increase, and the size of the nozzle will increase

  • The higher pressure in these larger nozzles typically results in the distribution of a greater quantity of adhesive as opposed to the quantity of adhesive that is necessary to generate the optimal level of adhesion

  • If just a little bit of adhesive is beneficial, then adding more adhesive might not necessarily be beneficial

  • In point of fact, there is a potential for a greater amount of adhesive to be wasted, which will unquestionably result in an increase in cost

Last but not least, when a piece of commercial adhesive is snipped off, it leaves behind what I call a tail. I can tell you from experience that the majority of operators dislike having to clean the equipment either during their shifts or after they have finished their shifts. Your overall purchase price or investment. Collaborate with professionals who are knowledgeable about adhesives, adjust your machinery so that it operates at the ideal temperature and pressure, and educate your machine operators and maintenance staff. In conclusion, but certainly not least, we should always keep a record of your results and work toward improving Bruce in order to achieve greater cost savings. Consider the implications. If we zero in on coal coke and get rid of it from the system, factory workers may be able to optimize their adhesive system and gain any other advantages.

In order to ensure a smooth transition from EVA to PUR, it is absolutely necessary to use up every last bit of the rubber's supply before making the switch. Put the cardboard under the coating roller as many times as necessary until there is no more glue visible on the surface of the cardboard. You are free to perform as many passes as you deem necessary. Both the temperature, which ought to be lowered to somewhere in the range of 110 and 140 degrees Celsius, and the quantity of application that ought to be carried out ought to be scaled back. Pay careful attention to the precise temperature that is specified in the data sheet for the web type that you use for your hot melt adhesive, and make sure that you write it down. Check the temperature of the by inspecting both the glue tank and the applicator roll